Optimasi Parameter Gravitasi Shot Peening Terhadap Kekasaran, Kekerasan dan Struktur Mikro ST 45 dengan Metode Taguchi
Abstract views: 69
,
PDF downloads: 69
Abstract
Shot peening is a surface treatment method at low temperature by shooting steel balls that are continuously adjusted for pressure and speed until plastic deformation is produced. The optimal parameter of the shot peening process was tested with the taguchi distribution. The factors and levels used are processing time, shooting distance and air pressure used in the shot peening process. Observations were made by looking at changes in surface roughness, thickness reduction, hardness levels, wear and changes in the microstructure of ST 45 steel material. The greatest hardness of 240.39 HVN was obtained at 10 minutes, a distance of 10 cm and a pressure of 9 kg / cm². The results of the surface wear test with the smallest value of 0.00039 mm³ / kg.m were obtained at 5 minutes, a distance of 10 cm and a pressure of 7 kg / cm². The results of the microstructure test showed that the change in the grain size of the microstructure of the material became flatter and smaller, the gravity shot peening method improved the mechanical properties of the ST 45 material.
Copyright (c) 2021 Infotekmesin
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
