Desain dan Analisis Mata Pisau Pencacah Untuk Pengolahan Sampah Plastik Menggunakan Finite Element Analysis
Abstract views: 293
,
PDF downloads: 285
Abstract
Plastic waste is one of the environmental problems in Indonesia. Plastic waste is a type of waste that is difficult to decompose, so it needs special handling for processing the problem. One alternative offered is by making a plastic chopper machine. One of the manufacturing of a machine is to design and analyze the components used. The blade is one of the important components of a plastic chopper. Model simulation of the blade itself needs to be done to analyze the performance of the blade during the performance of the machine. Simulation modeling is done using CAE software.. The form of meshing in the blade model is using tetrahedral and the meshing ratio is close to 1. The results obtained from the blade modeling process are the maximum Von mises stress on the loading of 300N, 500N, and 700N respectively at 6.752 x 10-3 MPa, 2.845 x 10- 3 MPa and 1,575 x 10-3MPa. While the amount of displacement in the variation of loading 300N, 500N, and 700N respectively has a value of 6.752 x 10-2 mm, 1.125 x 10-1 mm and 1.575 x 10-1 mm. The safety factor in this simulation is produced which has a value of 15, which means it is safe for all loading variations because it has a value of more than 1.
Copyright (c) 2020 Infotekmesin
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
